Scholars Central

Research articlePublished 31 Dec 2013

Performance and empirical models of a heat pump water heater system with heat recovery of waste water

Authors: Handong Wang

Journal of Chemical and Pharmaceutical Research

Volume 5 · Issue 12 · Pages 525–531

Ask about this article

Abstract

Select any words in the title or abstract, or press this and choose a sentence.

In order to save energy, the author developed a type of air-wastewater source heat pump (AWSHP) water heater system. What presented here is about the experimental performance and empirical models of the AWSHP system. Experiments and analysis showed that when the temperatures of waste water and city water varied in the ranges of 16.9~35.1 °C and 18.3~32.6 °C, respectively, the AWSHP system could produce 41.2~53.9 °C hot water with flow rate of 3.53×10-5~9.31×10-5 m3/s. The coefficient of heating performance (COPh) varied from 3.89 to 5.35. On the basis of energy balance, synthetic degree of grey incidence (SDGI) and grey-box methods, it was found that the COPh and hot water flow rate depended on the ratio of inlet and outlet temperature differences of waste water and hot water, i.e. ΔTw/ΔTh. The input power of compressor was proportional to the outlet temperature of hot water. Thus, the empirical correlation equations were obtained.

Ask about this article

Answers come only from this article's title, abstract and keywords, each sentence pointing to where it comes from. Your question is sent to OpenAI to write the answer. Scholars Central does not store it.

Try:

More from this journal

The newest in Journal of Chemical and Pharmaceutical Research.

All its articles

Conferences in this field

Upcoming conferences in this field.

Follow

New articles from what you follow go into your email digest, once you agree to alert emails.

  • JournalJournal of Chemical and Pharmaceutical Research
  • SubjectPharmaceutical Sciences
  • SubjectChemistry
  • BylineArticles whose byline prints “Handong Wang”