Conference abstractPublished 31 Aug 2020
Graphene�Coated Spandex Sensors for Composites Health Monitoring
Abstract
Select any words in the title or abstract, or press this and choose a sentence.
Internet of Things has been recently evolved by the state-ofthe-art piezoresistive nanocomposite strain sensors due to their high sensitivity and flexibility. Such versatile sensors involve a nanoscale percolating conductive network elaborated into a non-conductive, flexible polymeric matrix.Electrically-conductive polymeric composites have attracted increasing attention owing to their prominent capabilities in applications such as structural health monitoring, human motion detection, and traffic monitoring [1]. The study presented here aims at the development of low-cost, sensitive, and stretchable yarn sensors based on spandex (SpX) yarns coated with graphene nanoplatelets (GnP) through a dip coating process:SpX yarns were cut into 50-mm pieces, and coated with graphene nanoplatelets through a multi-step dip coating process. In each step, the yarns were dipped into a 1 wt.% solution of graphene in deionized (DI) water agitated for 3 sec. This was followed by the dehydration process performed by leaving the yarn on a hotplate at 100 °C for 1 min before the next dipping cycle. After the coating cycles were accomplished, the conductive yarns were attached to carbon fiber tow electrodes from their two ends using silver epoxy at 25 mm distance (i.e. the sensor’s gauge length). Wash durability and GnP protection was attained by embedding the SpX/GnP sensors into a stretchable silicone rubber (SR) sheath through spin coating. For this purpose, the GnP-coated SpX yarn along with the carbon fiber electrodes was attached to the back side of a 100 mm diameter petri dish. 3 ml of the rubber base polymer was poured onto the petri dish, covering the sensor through spin coating at 200 rpm for 20 sec. The silicone layer was then cured at room temperature for 24 h (resulting in ~1 mm thick silicone sheath encompassing the conductive yarn). The sensor was cut into 3-mm pieces and then detached from the petri-dish surface.
Subjects
EngineeringMaterials ScienceAsk about this article
Answers come only from this article's title, abstract and keywords, each sentence pointing to where it comes from. Your question is sent to OpenAI to write the answer. Scholars Central does not store it.
Follow
New articles from what you follow go into your email digest, once you agree to alert emails.
- JournalJournal of Materials Engineering and Applications
- SubjectEngineering
- SubjectMaterials Science
- BylineArticles whose byline prints “Mina Hoorfar”
