Article · 19 Feb 2026
Conference abstractPublished 7 Oct 2013
Evaluation of effect of different solvents on the oxidation of benzyl alcohol and cyclohexanol using modified clays
Abstract
Select any words in the title or abstract, or press this and choose a sentence.
Oxidation of benzyl alcohol to benzaldehyde and cyclohexanol to cyclohexanone was used as a model reaction to check the activity of modified clays (Surfactant immobilized- interlayered-manganate & chromate clays and metal cation exchanged clays impregnated with manganate /chromate) in presence of different solvents (like benzene, hexane, acetonitrile, ethyl acetate, n-butyl acetate and benzyl acetate). Study was carried out to evaluate the effect of different solvents (both polar and non polar) on the yield of the products obtained after the oxidation of benzyl alcohol and cyclohexanol. Polar solvents showed higher yield compare to non polar solvents. The yield was also found to increase with high boiling solvents. It is observed that as boiling point of solvents increases it enhances the rate of the reaction. Oxidation of benzyl alcohol and cyclohexanol can be carried out by conventional method using oxidizing agents in presence of Bronsted acids such as H2SO4, HF and HCl. But these catalysts are corrosive, non-reusable, difficult to isolate from the reaction mixture, form unwanted side products, difficult to handle and require tedious work up procedure. The increasing environmental pollution and economical constraints encouraged chemists to develop clean and high performance catalysts. In this direction, attention has been paid to heterogeneous or heterogenized clay catalysts system in presence of various solvents for oxidation reactions which are eco friendly, low cost etc. Thus modified clays in presence of different solvents could be advantageously used in the oxidation of alcohols.
Subjects
EngineeringMaterials ScienceAsk about this article
Answers come only from this article's title, abstract and keywords, each sentence pointing to where it comes from. Your question is sent to OpenAI to write the answer. Scholars Central does not store it.
More from this journal
The newest in Journal of Material Sciences & Engineering.
Perspective · 29 Dec 2025
Nanostructured Thin Films: Advancing Next-Generation Electronics
Brief report · 29 Dec 2025
Microstructural Defects: Impact on Material Properties and Performance
Conferences in this field
Upcoming conferences in this field.
Follow
New articles from what you follow go into your email digest, once you agree to alert emails.
- JournalJournal of Material Sciences & Engineering
- SubjectEngineering
- SubjectMaterials Science
- BylineArticles whose byline prints “N. Suma”
- BylineArticles whose byline prints “Pushpa Iyengar”
