Scholars Central

Conference abstract

Study of the behavior of vapor fraction in a turbo pump inducer using an X-ray tomography

Authors: Walid Hassan

Ask about this article

Abstract

Select any words in the title or abstract, or press this and choose a sentence.

This work intended to study the behavior of the instantaneous vapour fraction in the turbo-pump inducer of a liquid propellant rocket engine. Experimentations held on an experimental pump test facility and cavitations was attained by reducing the inlet pressure in the machine while maintaining constant the inducer rotational speed. Measurements of vapour fraction through the rotating inducer were achieved by means of an x-ray-based system. The system exerted an industrial x-ray generator and 10 collimated scintillation detectors. Detectors were functioning in current mode thus permitting an acquisition at 5 kHz for each detector. A reference x-ray detector situated between the x-ray generator and the machine permitted the treatment of x-ray beam energy fluctuations related to industrial generators Acquisitions were performed in three axial positions on the inducer. For each measurement position, three cavitations sequences with different flow rate conditions (Q/Qn=0.9, 1, 1.1, where Qn is the nominal flow rate) were accomplished. Each cycle is performed by decreasing gradually the pressure while maintaining an imposed rotational speed of 4000 rpm. Each test is constituted of 10 pressure points varying from 2.40 to 0.48 bars representing a complete cavitations sequence. X-ray acquisition was performed for each pressure point and it was carried out for 10 seconds thus corresponding to 667 tours of the inducer. Vapour fraction was determined instantaneously thus showing the applicability and the precision of the method in such measurements despite of the geometry and rotation speed constraints. Consequently a quantitative and qualitative evaluation of the vapour fraction is presented. Results show that the vapour distribution is well related to cavitations development on the blades of the inducer for steady cavitations condition. A cavitations regime mostly synchronous with the rotation of the inducer was detected. This permitted the use of tomographic reconstruction for the localization of vapor in the machine. An algebraic reconstruction algorithm (ML-EM) was used to achieve image reconstruction

Subjects

Engineering

Ask about this article

Answers come only from this article's title, abstract and keywords, each sentence pointing to where it comes from. Your question is sent to OpenAI to write the answer. Scholars Central does not store it.

Try:

More from this journal

The newest in Journal of Applied Mechanical Engineering.

All its articles

Conferences in this field

Upcoming conferences in this field.

Follow

New articles from what you follow go into your email digest, once you agree to alert emails.

  • JournalJournal of Applied Mechanical Engineering
  • SubjectEngineering
  • BylineArticles whose byline prints “Walid Hassan”