Article · 19 Feb 2026
Conference abstractPublished 17 Jul 2017
Gap opening and tailoring of graphene band structure
UniversitÃ?© Paris-Sud, France
Abstract
Select any words in the title or abstract, or press this and choose a sentence.
The disadvantage of graphene for using digital electronics is lack of bandgap, which is necessary to perform on-off switching operations in transistors. We have shown three different approaches to open a gap in graphene and tailor its electronic band structure. This includes (1) nanostructuration of graphene into graphene nanoribbons, (2) preparing a well-ordered buffer layer graphene and (3) introduction of a super-periodic potential in graphene grown on vicinal noble metal substrates. In our first approach to control graphene band structure, we have considered graphene ribbons grown on facets of the SiC (0001) surface. Our morphological characterization by scanning tunneling microscope (STM) and cross sectional transmission electron microscope (TEM) shows the presence of mini-ribbons bordering a central extended ribbon. These mini-ribbons have a width of 1-2 nm and promote an electronic confinement gap of more than 0.5eV as observed by photoemission, in an otherwise decoupled graphene from the substrate. We have also studied the first stages of graphene growth. On SiC (0001) substrate, under adequate growth conditions, a well ordered first single layer graphene (i.e. the buffer layer) exhibits again a bandgap of more than 0.5eV. The origin of this bandgap was unclear, so we used STM, TEM angle-resolved photoemission spectroscopy (ARPES) together with calculations. This comprehensive study demonstrated that the bandgap opening is due to the super periodicity induced by the substrate. Finally, we induced different super-periodicities on the underlying substrate to tailor grapheneâÂ?Â?s electronic properties. The nanostructuration of two substrates, Ir(332) and a multivicinal curved Pt(111) substrate induces a superperiodic potential on graphene that opens mini-gaps on the ÏÂ? band as observed by ARPES and consistent with the structural periodicity observed in STM and low energy electron diffraction.
Subjects
EngineeringMaterials ScienceAsk about this article
Answers come only from this article's title, abstract and keywords, each sentence pointing to where it comes from. Your question is sent to OpenAI to write the answer. Scholars Central does not store it.
More from this journal
The newest in Journal of Material Sciences & Engineering.
Perspective · 29 Dec 2025
Nanostructured Thin Films: Advancing Next-Generation Electronics
Brief report · 29 Dec 2025
Microstructural Defects: Impact on Material Properties and Performance
Conferences in this field
Upcoming conferences in this field.
Follow
New articles from what you follow go into your email digest, once you agree to alert emails.
- JournalJournal of Material Sciences & Engineering
- SubjectEngineering
- SubjectMaterials Science
- BylineArticles whose byline prints “Antonio Tejeda”
