Article · 19 Feb 2026
Conference abstractPublished 12 Jun 2017
Melt infiltration casting of alumina, silicon carbide and boron carbide reinforced aluminium matrix composites
Middle East Technical University, Turkey
Abstract
Select any words in the title or abstract, or press this and choose a sentence.
A series of metal matrix composites were produced using 7075 and 7085 aluminum alloys as matrix alloys and Al2O3, SiC and B3C4 seramic preforms. Melt infiltration casting was performed with a vertical squeeze caster applying 70 ton pressure during processing. Sintering of ceramic preforms were carried out at 1000, 1100 and 1300Ã?ºC for one hour then preheated hot sintered preforms at 1000Ã?ºC were placed into a die cavity before aluminum infiltration casting. During processing vertical 70 ton and upward 40 ton hold down pressure was applied for three minutes for melt infiltration. Mechanical characterizations were done by three point bending tests and flexure strength values obtains for 7075 alloy infiltrated Al2O3 preforms as 520-600 MPa.
Subjects
EngineeringMaterials ScienceAsk about this article
Answers come only from this article's title, abstract and keywords, each sentence pointing to where it comes from. Your question is sent to OpenAI to write the answer. Scholars Central does not store it.
More from this journal
The newest in Journal of Material Sciences & Engineering.
Perspective · 29 Dec 2025
Nanostructured Thin Films: Advancing Next-Generation Electronics
Brief report · 29 Dec 2025
Microstructural Defects: Impact on Material Properties and Performance
Conferences in this field
Upcoming conferences in this field.
Follow
New articles from what you follow go into your email digest, once you agree to alert emails.
- JournalJournal of Material Sciences & Engineering
- SubjectEngineering
- SubjectMaterials Science
- BylineArticles whose byline prints “Ali Kalkanli”
