Conference abstractPublished 12 Jun 2017
Fabrication of nanoporous graphene membranes for nanofiltration applications
Polytechnic University of Turin, Italy
Abstract
Select any words in the title or abstract, or press this and choose a sentence.
Nowadays, membrane technology often relies on the use of porous substrates to selectively separate specific compounds from fluids. To improve the separation efficiency and reduce the operating costs, new generation membranes are highly desirable and for numerous applications, like water desalination, oil/water separation as for the isolation and/or extraction of specific biological moieties. A possible solution is to reduce the thickness of the membrane as much as possible. Thanks to their one-atomic-layer thickness coupled with excellent mechanical strength and chemical stability, graphene-based membranes recently gained lots of attention. Several studies showed that graphene with stand strong pressure regimes (up to 57 MPa), while excellent water permeability, high flow rates and promising salt rejection are possible if controlled nanopores are opened within the graphene layer. The present study deals with the fabrication of nanoporous graphene membranes based on CVD-grown monolayer graphene, and porous polycarbonate membranes (PCTE) as supports. Graphene was grown on Cu foils by thermally-activated low-pressure chemical vapor deposition and transferred onto the PCTE supports by following a simple and fast direct transfer procedure. The quality of graphene on Cu foils and PCTE membranes was checked by Raman spectroscopy. After the transfer, FESEM analyses highlighted the good graphene coverage of PCTE, and pointed out the presence of intrinsic graphene defects at the nanoscale. Finally, the water flux and methylene blue (MB) filtration across the nanoporous graphene/PCTE membranes were evaluated in a dead-end cell filtration apparatus. In conclusion, Raman spectroscopy and FESEM analyses confirmed the good quality of monolayer graphene, before and after the transfer process. The presence of intrinsic defects was also observed, allowing for water permeability and molecular selectivity to be obtained. Accordingly, our preliminary results showed that water permeability together with around 90% MB rejection could be obtained for a convenient choice of the polymeric support together with the presence of intrinsic nanopores.
Subjects
EngineeringMaterials ScienceAsk about this article
Answers come only from this article's title, abstract and keywords, each sentence pointing to where it comes from. Your question is sent to OpenAI to write the answer. Scholars Central does not store it.
Conferences in this field
Upcoming conferences in this field.
Follow
New articles from what you follow go into your email digest, once you agree to alert emails.
- JournalJournal of Material Sciences & Engineering
- SubjectEngineering
- SubjectMaterials Science
- BylineArticles whose byline prints “Marco Laurenti”
- BylineArticles whose byline prints “Seifeddine Kara”
- BylineArticles whose byline prints “Marco Fontana”
- BylineArticles whose byline prints “Stefano Bianco”
- BylineArticles whose byline prints “Elena Tresso”
- BylineArticles whose byline prints “Candido Fabrizio Pirri”
- BylineArticles whose byline prints “Sergio Ferrero”
- BylineArticles whose byline prints “Luciano Scaltrito”
