Scholars Central

Conference abstractPublished 26 Oct 2016

Carbon nanotubes/polypyrrole film as a gas sensor for the volatile organic compounds

Authors: Shams B Ali, Benjamin R Horrocks, Andrew Houlton

Newcastle University, UK

Ask about this article

Abstract

Select any words in the title or abstract, or press this and choose a sentence.

This research concerns the physical and structural properties of carbon nanotube/conductive polymer composites and their use in gas sensors. A good sensor should be sensitive, reliable and low cost, with fast response and a short recovery time. Carbon nanotubes (CNTs) are well-suited because of their unique properties; their small size, hollow center, large surface area and good electric conductivity. However, it has been shown that pristine carbon nanotubes have a low response for volatile organic compoundsâÂ?Â?our target analyte-therefore we attempted to improve this property of CNTs by templating pyrrole on CNTs. TEM, Raman spectroscopy, I-V characteristics and voltammetry were used to study the structural properties of CNTs/Polypyrrole. Polypyrrole is simple to prepare by oxidation of the monomer and its resistance is very sensitive to organic vapors, although much larger than that of CNTs. TEM of polypyrrole/CNT composites prepared from single-walled carbon nanotubes (SWCNTs) and multi-walled carbon nanotubes (MWCNTs) show polypyrrole coated the CNTs successfully. There are significant changes in the range of diameters of nano tubes for SWCNTs from (7-10) nm to (8-35) nm and from (2-10) to (21-50) nm for MWCNTs. The composites were tested for the variation in their resistance upon exposure to a range of organic vapors (acetone methanol and chloroform). The sensing devices comprised simple two-terminal devices over which a layer of the composite was applied by drop-coating. We investigated the effect of the CNT: polypyrrole ratio on the sensor response, S=(R-R0)/R0 where R0 is the resistance in an air atmosphere and R is the resistance at steady-state after exposure to an air/analyte mixture. In general, bare CNTs show a rapid response time, but very low response (typically S<0.1) at room temperature. As the amount of polypyrrole in the composite is increased, S increases, the response time deteriorates. Interestingly, the response of the composites may even change sign as a function of target analyte concentration; this suggests that a simple mechanism based on swelling and its effect on the percolation behavior of CNTs in the polypyrrole matrix is insufficient to explain the data.

Ask about this article

Answers come only from this article's title, abstract and keywords, each sentence pointing to where it comes from. Your question is sent to OpenAI to write the answer. Scholars Central does not store it.

Try:

More from this journal

The newest in Journal of Material Sciences & Engineering.

All its articles

Conferences in this field

Upcoming conferences in this field.

Follow

New articles from what you follow go into your email digest, once you agree to alert emails.

  • JournalJournal of Material Sciences & Engineering
  • SubjectEngineering
  • SubjectMaterials Science
  • BylineArticles whose byline prints “Shams B Ali”
  • BylineArticles whose byline prints “Benjamin R Horrocks”
  • BylineArticles whose byline prints “Andrew Houlton”