Article · 19 Feb 2026
Research articlePublished 2019
Finite Element Analysis of Chemical Assisted Ultrasonic Machining Process to Investigate the Effect of Abrasive on Polycarbonate (UL-752) Glass and USM Tool
Abstract
Select any words in the title or abstract, or press this and choose a sentence.
In this research paper, the Finite Element Analysis is used for the investigation. The modal of polycarbonate bullet proof glass and the abrasive particle is prepared to study the effect of machining mechanism. Through analysis, it concludes that hard abrasive gives the large stressed zone, which increases the material removal rate. In this experimental study, Boron carbide abrasive gives better material removal rate as compared to Silicon carbide and Alumina Abrasive. It also observed from the analysis, higher material removal rate also encourage the tool wear rate. Boron carbide gives higher tool wear rate as compare to other abrasive. The results are verified with the experimentation, it gives the approximately same results of Finite Element Analysis.
Keywords
Subjects
EngineeringMaterials ScienceAsk about this article
Answers come only from this article's title, abstract and keywords, each sentence pointing to where it comes from. Your question is sent to OpenAI to write the answer. Scholars Central does not store it.
More from this journal
The newest in Journal of Material Sciences & Engineering.
Perspective · 29 Dec 2025
Nanostructured Thin Films: Advancing Next-Generation Electronics
Brief report · 29 Dec 2025
Microstructural Defects: Impact on Material Properties and Performance
Follow
New articles from what you follow go into your email digest, once you agree to alert emails.
- JournalJournal of Material Sciences & Engineering
- SubjectEngineering
- SubjectMaterials Science
- BylineArticles whose byline prints “Kanwal Jit Singh”
