Scholars Central

Research articlePublished 2018

Reversion of Martensite in 304 Stainless Steel Studied by Dilatometry and Calorimetry

Authors: Graham CD, Lorenz BE, Michael Citrin, Debby Greenstein, Raymond Xu

Journal of Material Sciences & Engineering

Volume 7 · Issue 2 · Pages 1–4

Ask about this article

Abstract

Select any words in the title or abstract, or press this and choose a sentence.

Dilatometry has been used to confirm that the reversion of deformation-induced martensite in Type 304 stainless steel occurs principally sin the temperature range 425 to 650°C, and to show that the reversion is a thermal or not diffusion controlled. An attempt to correlate the change in length of cold-drawn 304 wire samples on heating to 800°C with the martensite content determined from the measured saturation magnetization was only qualitatively successful. The heat of reversion of martensite in cold-drawn wire samples was found by differential scanning calorimetry to be in the range 1800 to 2200 J/mol in cold-drawn 304 wires, in reasonable agreement with values for the heat of formation of martensite in 4340 steel determined by a completely different method. We also observe an exothermic reaction near 650°C of a few hundred J/mol which we ascribe to the recrystallization of cold-worked austenite.

Ask about this article

Answers come only from this article's title, abstract and keywords, each sentence pointing to where it comes from. Your question is sent to OpenAI to write the answer. Scholars Central does not store it.

Try:

Follow

New articles from what you follow go into your email digest, once you agree to alert emails.

  • JournalJournal of Material Sciences & Engineering
  • SubjectEngineering
  • SubjectMaterials Science
  • BylineArticles whose byline prints “Graham CD”
  • BylineArticles whose byline prints “Lorenz BE”
  • BylineArticles whose byline prints “Michael Citrin”
  • BylineArticles whose byline prints “Debby Greenstein”
  • BylineArticles whose byline prints “Raymond Xu”