Scholars Central

Conference abstract

Influence of mold oscillation during solidification on grain size, degree of grain refinement and tensile properties of the A356 and A319 aluminum alloys

Authors: S P Tewari, Sakendra Kr

Ask about this article

Abstract

Select any words in the title or abstract, or press this and choose a sentence.

A356 and A319 aluminum alloys were cast under stationary and oscillation condition. The frequency range selected was 0 Hz to 400 Hz with constant amplitude of 15 μm. It has been observed on the basis of experimental results that intensity of oscillation, in general enhances mechanical properties such as ultimate tensile strength, yield strength and percentage elongation of casting along with reduction of grain size of α-Al. The mechanical and metallurgical properties are appreciably improved at a higher frequency of oscillation. This may be due to the increase in number of nucleation sites because of fracturing of grains due to oscillation. Rapid ejection of heat of molten metal takes place due to mold oscillation at interface during solidification. This brings about grain refinement and modification of eutectic cells in castingRecent Publications 1. Sakendra Kumar and S P Tewari (2017) Metallurgical and mechanical characterization of A319 aluminum alloy casting solidified under mould oscillation. International Journal of Metal Casting ISSN: 1939-5981. 2. Sakendra Kumar, S P Tewari (2017) Effect of mold oscillation on the metallurgical characterization and mechanical properties of A319 aluminum alloy casting. International Journal of Cast Metals Research ISSN: 1364-0461. 3. Kumar S and Tewari S P (2016) Evaluation of microstructure of A356 aluminum alloy casting prepared under vibratory conditions during the solidification. Sādhanā ISSN: 0256-2499. 4. Jyoti Prakash, S P Tewari, Bipin Kumar Srivastava (2014) Effect of longitudinal weld pool oscillation (LWPO) on mechanical properties of AA 6101 T6 aluminium alloy welds. International Journal of Advanced Research in Engineering & Technology (IJARET) ISSN 0976-6499. 5. Tewari S P and Rathore Nitin (2010) Resistance spot weldability of low carbon and HSLA steels. Thammasat International Journal Science 15(1):1-11.

Subjects

Engineering

Ask about this article

Answers come only from this article's title, abstract and keywords, each sentence pointing to where it comes from. Your question is sent to OpenAI to write the answer. Scholars Central does not store it.

Try:

More from this journal

The newest in Journal of Applied Mechanical Engineering.

All its articles

Conferences in this field

Upcoming conferences in this field.

Follow

New articles from what you follow go into your email digest, once you agree to alert emails.

  • JournalJournal of Applied Mechanical Engineering
  • SubjectEngineering
  • BylineArticles whose byline prints “S P Tewari”
  • BylineArticles whose byline prints “Sakendra Kr”