Scholars Central

Conference abstractPublished 22 Sep 2016

Repair method of damaged steel braced structure and restoring force characteristics after repair state

Authors: Ryotaro Arai, Hanako Satoh, Kenta Aoki, Takumi Ito Changhoon Choi

Tokyo University of Science, Japan

Ask about this article

Abstract

Select any words in the title or abstract, or press this and choose a sentence.

A lot of steel structures have experienced severe earthquake disasters in Japan, and its various kinds of failure mode have been reported. Especially on steel braced structure, the failure modes are generally categorized into two modes; buckling and fracture of brace member, and yielding of joints and fasteners. After a lot of earthquake disasters, the technical manual has been published to repair and recover the damaged building structures in Japan. The manual suggests the actual repairing method for damaged steel braced structures; however, it is guessed that a few of these methods have some difficulties related to construction technique and estimation of recovery after repair. In this paper, new repairing method for joints on damaged steel brace structure has been proposed, and its applicability and feasibility are investigated experimentally. Herein, the horizontally loading test on diagonal steel brace are performed with parameters as follows; thickness of gusset plate, layout of bolts, slenderness ratio of brace and the method of joint. At first, the damaged state of gusset plate was reproduced by horizontally loading test. Next, the damaged gusset plate was repaired. Finally, the loading test was done to the repaired specimen again. From the test results, the strength was reinforced after repair, and the rigidity was almost same. The change of failure mode and slenderness ratio is presented, and which is related to eccentric distance and torsional parameters. Furthermore, the evaluation method of the failure mode and buckling strength are proposed, and this estimation method shows good utility.

Ask about this article

Answers come only from this article's title, abstract and keywords, each sentence pointing to where it comes from. Your question is sent to OpenAI to write the answer. Scholars Central does not store it.

Try:

Follow

New articles from what you follow go into your email digest, once you agree to alert emails.

  • JournalJournal of Civil and Environmental Engineering
  • SubjectEngineering
  • SubjectEnvironmental & Earth Sciences
  • BylineArticles whose byline prints “Ryotaro Arai”
  • BylineArticles whose byline prints “Hanako Satoh”
  • BylineArticles whose byline prints “Kenta Aoki”
  • BylineArticles whose byline prints “Takumi Ito Changhoon Choi”