Scholars Central

Conference abstractPublished 22 Sep 2016

Screw connections in cold-formed steel clip angles subjected to uplift forces

Authors: Cheng Yu

University of North Texas, USA

Ask about this article

Abstract

Select any words in the title or abstract, or press this and choose a sentence.

The paper presents a test program aimed at investigating the pull-over strength of screws installed on the anchored leg of the cold-formed steel clip angle connectors. Initial confirmatory tests showed that the tested pull-over strength was significantly less than the predicted values that were determined using AISI S100 (2012). Therefore, additional specimens were tested in order to develop an appropriate design method for the pull-over strength of screws used in CFS clip angles. The test results indicated that the pull-over strength of screws when used in clip angles would experience 50% reduction in nominal strength. A proposal to revise the current design provision in AISI S100 was presented in this paper along with complete details of the test program.

Ask about this article

Answers come only from this article's title, abstract and keywords, each sentence pointing to where it comes from. Your question is sent to OpenAI to write the answer. Scholars Central does not store it.

Try:

More from this journal

The newest in Journal of Civil and Environmental Engineering.

All its articles

Conferences in this field

Upcoming conferences in this field.

Follow

New articles from what you follow go into your email digest, once you agree to alert emails.

  • JournalJournal of Civil and Environmental Engineering
  • SubjectEngineering
  • SubjectEnvironmental & Earth Sciences
  • BylineArticles whose byline prints “Cheng Yu”