Conference abstract · 26 Nov 2020
Conference abstractPublished 22 Dec 2020
Ultraviolet Laser Lithography of Ceramic Micro Lattices for Electromagnetic Wave Modulations.
Abstract
Select any words in the title or abstract, or press this and choose a sentence.
Dielectric ceramic components were fabricated by ultraviolet laser lithography. 2D cross sections were created through dewaxing and sintering by UV laser drawing on spread resin paste including ceramic nanoparticles, and 3D composite models were sterically printed by layer laminations. As the row material of the lithography, ceramic nanoparticles from 500 nm in average diameters were dispersed in to liquid resins from 50 % in volume fraction. The resin paste was spread on a glass substrate at 50 μm in layer thickness by a mechanically moved knife edge. An ultraviolet laser beam of 355 nm in wavelength was adjusted at 10 μm in spot diameter and scanned on the pasted resin surface. Irradiation power was changed from 600 to 700 mW for enough solidification depth for 2D layer bonding. Scanning speed was changed from 50 to 100 mm/s to create fine lattice structures as shown in Figs. 1 (a), (b) and (c). The half wavelength of the incident ultraviolet ray should be comparable with the nanoparticles gaps in the resin paste, therefore the dewaxing and sintering will be realized through the electromagnetic waves resonations and localizations as shown in Fig. 1 (c). Through the layer lamination, the 3D titania structures with 97% in volume fraction were successfully fabricated. The titania crystal structure was analyzed as dual phase of anatase and rutile. After the reheating treatment at 1350 °C for 2 hs, titania components with rutile phase was obtained. The linear shrinkage through the sintering was < 1 %. The diamond lattice with four coordination number of 270 μm in periodicity could diffract electromagnetic waves of 0.25 to 0.45 THz, and exhibit forbidden gaps in transmission spectra for all spatial directions. The dielectric lattice especially is called photonic crystal.
Ask about this article
Answers come only from this article's title, abstract and keywords, each sentence pointing to where it comes from. Your question is sent to OpenAI to write the answer. Scholars Central does not store it.
Similar by topic
Conference abstract · 20 Sep 2020
Direct Ceramic Additive Manufacturing by Ultraviolet Laser Lithography
Conference abstract · 29 Aug 2020
Additive Manufacturing of Ceramic Components by Using Ultraviolet Laser Lithography
Conference abstract · 29 Feb 2016
Solvent-free fluidic organic distributed feedback lasers via soft-lithography
Conference abstract · 6 May 2022
Stereolithographic Additive Manufacturing of Photonic Crystal with Dielectric Patterns for Electromagnetic Wave Modulation
More from this journal
The newest in The Open Access Journal of Science and Technology.
Review article · 18 Aug 2023
Electrical Conductivity of DC, AC and Dielectric Properties of Polyaniline/NLS FA/Silver Nano Particle with Low Temperature Plasma
Commentary · 11 Jan 2023
Modern Engine Technology and its Components
Commentary · 11 Jan 2023
An Overview on a Novel Material like Shape Memory Alloy
Follow
New articles from what you follow go into your email digest, once you agree to alert emails.
- JournalThe Open Access Journal of Science and Technology
- SubjectPhysics & Astronomy
- SubjectMaterials Science
- BylineArticles whose byline prints “Soshu Kirihara”
