Scholars Central

Research articlePublished 2016

Gas Seal Performance and Start up Condition Enhancing with Different Seal Groove Geometries

Authors: Shahin I

Journal of Aeronautics & Aerospace Engineering

Volume 5 · Issue 4 · Pages 1–9

Ask about this article

Abstract

Select any words in the title or abstract, or press this and choose a sentence.

New dry gas seal “DGS” groove geometry has been developed, using a verified three dimensional simulations. The effect of the various groove profiles; standard spiral, tapered-spiral, spiral with an annulus and tapered-spiral with an annulus were studied at wide range of operating speed. The results indicate that, tapered type spiral groove causes a reduction in opening force and in the leakage rate. In addition, increasing the taper angle reduces the temperature distribution inside the gas film and reduces the thermal stresses on the seal mating rings. The combined use of annuals and taper spiral groove decrease the leakage rate for spiral DGS with annular groove only. The final optimized spiral tapered seal with annuals reduces the leakage rate by 18.5% from standard seal, ensures uniform pressure distribution and hydrostatic lift at low speeds, resulting in low torque and reliable operating at start-up condition.

Subjects

Engineering

Ask about this article

Answers come only from this article's title, abstract and keywords, each sentence pointing to where it comes from. Your question is sent to OpenAI to write the answer. Scholars Central does not store it.

Try:

More from this journal

The newest in Journal of Aeronautics & Aerospace Engineering.

All its articles

Conferences in this field

Upcoming conferences in this field.

Follow

New articles from what you follow go into your email digest, once you agree to alert emails.

  • JournalJournal of Aeronautics & Aerospace Engineering
  • SubjectEngineering
  • BylineArticles whose byline prints “Shahin I”