thin Pb-overcoat has been investigated though structural, morphological, compositional and electrical studies. Sputter deposited PZT thin films on Ti-substrates are found to contain a Pb-deficient
AlNxOy were grown on glass and silicon substrates by RF-reactive magnetron sputtering. The substrate deposition temperature was varied with the purpose of evaluating the composition variation, crystal structure…
Polycrystalline Cu2ZnSnS4 (CZTS) thin film has been grown on glass substrate by RF-magnetron sputtering at substrate temperature 573 K using a commercial target of same composition. Structural and optical
Zinc oxide (ZnO) thin films were deposited by RF magnetron sputtering onto glass substrates at room temperature. The thickness effect on the structural,morphological and optical properties
were deposited on (100) silicon substrates by RF magnetron sputtering using a powder target. The results show that the devices have good rectifying behaviors with an ideality factor values
Zinc tungstate (ZnWO4) films were produced using ion beam sputtering of ZnWO4 target. Crystalline structure and optical properties of films were examined with X-ray diffractometry, examination of luminescent properties
Submicron-gap electrodes were fabricated using focused ion beam (FIB) sputtering and applied as source/drain to scaled organic thin-film transistors (OTFTs). Fully focused Ga ions emitted fromliquid
supported Ag catalysts have been prepared by using pulsed Direct Current (DC) reactive magnetron sputtering of Ag targets in an Argon atmosphere onto P25-TiO2 support. The Ag doping content ... while acetaldehyde was…
hybrid electrode produced hybrid supercapacitors have been assembled for first time via RF magnetron sputtering technique to deposit MnO2 at carbon nanotube (CNTs) composite layer.The electrode synthesis has been done…
High power impulse magnetron sputtering (HiPIMS) is a new method for physical vapor deposition (PVD) based on magnetron sputtering. It utilizes transient impulse (short pulse) glow discharges with very high ... plasma…
synergistic effect of the simultaneous additions of chromium and aluminum in the sputter-deposited amorphous or/ and nanocrystalline W-44Cr-35Al alloys is studied in 1M HCl, 0.5M NaCl ... susceptible to pitting…
kinds of Si3N4/SiO2 dielectric quarter-wave stacks prepared by a reactive pulsed magnetron sputtering technique was presented. The numerical simulation of multilayer stress behavior by using the MATLAB software
this study, we measured the absorption spectrum of Ti atom in a facing target sputtering (FTS) system by using a Ti: sapphire laser. It is difficult to determine the parameters
gingivalis (P. gingivalis) via crystal violet staining assay on titanium surface modified by TiN sputter coating and plasma nitriding on titanium. The specimens were divided into 3 groups; polished titanium ... control…
known positive effects of TiO2, SiO2 and Ag nanoparticles, and employing magnetron co-sputtering as an ecology friendly and relatively easy technology. Magnetron co-sputtered TiO2/SiO2/Ag coatings with
properties. It has got applications in semiconductor devices, sensors and solar cells. Reactive magnetron sputtering deposition of nickel oxide (NiO) films were done on p-type silicon substrate and glass
investigated the corrosion behavior of sputter-deposited nanocrystalline W-Mo alloys with different atomic percentage in neutral medium at 25°C, open to air, by electrochemical measurements including weight loss
prepare ZnO:Al thin films with good crystallinity by helicon wave excited magnetron sputtering method and aimed to establish conditions for preparation. ZnO:Al thin films prepared by this method
spinodal transformation. Pure thin films of Co1.7Fe1.3O4 spinel iron cobaltites were prepared by rf sputtering. The two-phase spinels obtained through the spinodal transformation were evidenced after annealing
required. The growth of CuCrO2:Mg delafossite thin film on quartz substrate by rf sputtering is first reported in this work. The deposition leads to a nanocrystalline phase. Delafossite characteristic
deposited at a substrate temperature of 250°C for 1 hour by using DC Sputtering technique. The as synthesized target was TiO2-SnO2 was used to deposit on the glass
sodium salts of tungstate and nitrite, as the green corrosion inhibitors on the sputter-deposited nanocystalline W-42Cr-5Ni alloy was investigated in 0.5 M NaCl solution open
Paper (CP) by spray method. A Cobalt (Co)-based electro catalyst was fabricated by sputter deposition on GO layered CP and then subjected to a heat treatment in an ammonia